Code-3 Z3 Siren Installation & Operation Manual Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Code-3 Z3 Siren Installation & Operation Manual. Code 3 Z3 Siren Installation & Operation Manual User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 24
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
1
INSTALLATION
& OPERATION
MANUAL
WARNING
Sirens produce loud sounds that may damage hearing
Wear hearing protection when testing
Use siren only for emergency response
Roll up windows when siren is operating
Avoid exposure to the siren sound outside of vehicle
Read all instruction and warnings before installing and using.
INSTALLER: This manual must be delivered to the end user of this equipment.
IMPORTANT:
Zobrazit stránku 0
1 2 3 4 5 6 ... 23 24

Shrnutí obsahu

Strany 1 - & OPERATION

1INSTALLATION & OPERATION MANUALWARNINGSirens produce loud sounds that may damage hearing• Wear hearing protection when testing• Use siren only f

Strany 2

10WARNING!Connection of a 58 watt speaker to the siren amplifi er will cause the speaker to burn out, and will void the speaker warranty!WARNING!Any e

Strany 3 - Computer Confi gurable

11CC ArrowStik ConnectionThe Z3 Siren can connect directly to any Code 3 Centrally Controlled (CC) ArrowStik and some non-Code3 CC ArrowStiks using Co

Strany 4 - Computer Confi gurable-Cont:

12Figure 6Figure 7NON-CC WIRING CONNECTIONS5('/$552:%/8(',0:+,7()/$6+25$1*(5$552:Figure 8%52:1287387*5((12873877$1

Strany 5

13Troubleshooting(Refer to wiring diagram on page 15.)PROBLEM PROBABLE CAUSE REMEDYNO SIREN OUTPUT A. PARK KILL ACTIVATEDB. SIRENLOCK ENGAGEDC. SHORTE

Strany 6 - Not Confi gurable

14(Refer to wiring diagram on page 15.)PROBLEM PROBABLE CAUSE REMEDYTHE GREEN, AMBER, AND/OR RED LEDS FLASH RAPIDLY AND CONTINUOUSLY.A. ONE OR MORE OF

Strany 7 - FACTORY SETTINGS

15AMPLIFIERLEVEL 1LEVEL 2LEVEL 3ALEVEL 3B+12VDC (3-LEVEL)+12VDC (AUX)GNDAUX HAUX GAUX FAUX EAUX DAUX CAUX BAUX ATO LIGHTBAR30A FUSED30A FUSED20A FUSED

Strany 8

16Siren Section: Input Voltage 10 to 16 VDC and ground - 12V units (Note: Operation of 12V units above 15 VDC for an extended period of time ma

Strany 9

17

Strany 10

18Ref No. Description Purchasable Part No. Internal Part No. (Not For Sale) Qty.1 8-32 X 1/4” Hex Head MS T10385

Strany 11

19

Strany 12 - 5('/$552:

2!Sirens are an integral part of an effective audio/visual emergency warning system. However, sirens are only short range secondary warning devices.

Strany 13 - Troubleshooting

20Ref No. Description Purchasable Part No. Internal Part No. (Not For Sale) Qty.1 Amplifi er E Tray T15305 All Amplifi er Compone

Strany 14

21NOTES

Strany 16

23NOTES

Strany 17

24WARRANTY Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and oper

Strany 18

3Control Head Confi gurable (In Vehicle)Adjustable Backlighting - The Backlighting can beadjusted as desired. Press and hold either the LEFT or RIGHT p

Strany 19

4Computer Confi gurable-Cont:Auxiliary A-H Push-Buttons -As confi gured by the Z3 Siren Confi guration Software, eight on/off Auxiliary push-buttons are

Strany 20

5Computer Confi gurable-Cont:Scroll On/Off - The Scroll On/Off mode works like the Scroll mode except the Z3 Siren will scroll the primary tones throug

Strany 21

6Not Confi gurableAlarm - Connect the wire labeled ALARM to a circuit that can supply a +12VDC signal when activated. When a +12VDC signal is seen on t

Strany 22

7FACTORY SETTINGSSetting 1 Setting 2 Setting 3 Setting 4 Setting 5 Setting 63-Level Switch Function = ProgressiveLevel 1 Function Enabled Horn Ring Tr

Strany 23

8After unpacking your Z3 Siren, carefully inspect the unit and associated parts for any damage that may have been caused in transit. Report any damage

Strany 24 - PRODUCT RETURNS

9All Amplifi er connections are made on one side of the Amplifi er (see Figure 4). See wiring diagram on page 15. All Amplifi er connections are quick di

Komentáře k této Příručce

Žádné komentáře