Code-3 930 and 940 Flashers Uživatelský manuál stáhnout pdf (Strana 5)

NOTE: For continued Alley light flash while in low beam, do not connect Terminal 1.

8) Connect the negative (-) post of the battery, or other good ground(earth), to Terminal 11 of the

Flasher Unit.

9) Connect a user supplied switch between the positive (+12VDC) source and Terminal 3 of the

Flasher Unit. This switch will override the flash feature and cause the Left Alley Light

to operate in steady burn mode.

10) Connect a user supplied switch between the positive (+12VDC) source and Terminal 4 of the

Flasher Unit. This switch will override the flash feature and cause the Right Alley Light

to operate in steady burn mode.

If you are installing the Model 930 flasher, proceed to Testing the Flasher on Page 6. If you are installing

flasher Model 940 continue with step 11 below.

Continued Flasher Installation (Model 940)

To install the Model 940 as a Takedown / Alley Light flasher, complete the above outlined steps and then

refer to Figure 2 for the following steps:

11) Connect the Right Takedown Light to Terminal 7 of the Flasher Unit.

12) Connect the Left Takedown Light to Terminal 6 of the Flasher Unit.

13) Connect a user supplied switch between the positive (+12VDC) source and Terminal 5 of the

Flasher Unit.

14) Connect a user supplied switch between the positive (+12VDC) source and Terminal 8 of the

Flasher Unit. This switch will override the Takedown flash feature and cause the Takedown

Lights to operate in steady burn mode.

Double check all of your connections then refer to the section on testing the circuit.

FIGURE 2: WIRING DIAGRAM FOR 940

LIGHT BAR FLASHER INSTALLATION

1 2 3 4 5 6 7 8

Žádné komentáře

Code-3 930 and 940 Flashers Uživatelský manuál Strana 5