Code-3 Defender Uživatelský manuál stáhnout pdf (Strana 8)

Take Down and Alley Flash

Selecting Flash Patterns:

The Take Down and Alley Lights can be programmed to ash at different rates.

STEP 1:

Power-up the light bar. Select the Take Down Flash Mode (BLK) or the Alley Flash Mode (BLU/WHT) by applying +power to the appropriate wire. .

NOTE: Make sure +12v is only applied to the function you are trying to program - otherwise program function will not operate.

STEP 2:

Observe the ash pattern and determine which pattern is in operation (see Table 3). This table shows the available ash patterns. Once the ash

pattern has been determined, proceed to Step 3. NOTE: The default ash pattern for Take Down and Alley Lights is Medium Single 115FPM.

STEP 3:

Scroll to the next pattern by momentarily holding the BLK/RED wire to +power for ~one (1) second. The light bar will stop ashing when the wire

is connected to +power. Release the wire and the next pattern as listed in Table 3 will begin to ash. The new pattern is automatically stored each

time. NOTE: To restore the Factory Default Take Down and Alley Flash Patterns, hold the BLK/RED wire to +power for ~four (4) seconds.

TABLE 3

TAKE DOWN AND ALLEY FLASH PATTERNS

PATTERN NUMBER PATTERN DESCRIPTION

1 FAST QUAD 80FPM

2 SLOW QUAD 60FPM

3 FAST SINGLE 375FPM

4 MEDIUM SINGLE 115FPM

5 SLOW SINGLE 60FPM

6 FAST DOUBLE 115FPM

7 SLOW DOUBLE 60FPM

8 FAST SIX 80FPM

9 SLOW SIX 60FPM

10 VARIABLE RATE SINGLE

11 NFPA QUAD 75FPM

12 CYCLE FLASH

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Code-3 Defender Uživatelský manuál Strana 8