Code-3 CPS690 Remote Strobe Power Supply Uživatelský manuál

Read all instructions and warnings before installing and using.INSTALLER: This manual must be delivered to the end user of this equipment.INSTALLATI

NOTES10

NOTES11

Code 3 is a registered trademark of Public Safety Equipment, Inc.CycleFlash is a trademark of Public Safety Equipment, Inc.Public Safety Equipment (U

IntroductionThe CPS690 Series Remote Strobe Power Supply represents the latest in state-of-the-art strobe warningtechnology. The latest in MOSFET tech

Unpacking and Pre-installationRemove the power supply from the box and examine the unit for any transit damage. Report any damage to thecarrier immedi

4Installation and Mounting1. First install the CPS690 strobe power suppy in a protected location using the power supply itself as atemplate. THE POWER

5NOTE: IT IS IMPORTANT TO FOLLOW THE CORRECT COLOR CODEWHEN INSERTING THE PINS INTO THE AMP 3 PIN CONNECTORS.4. Connect the cables to the strobe light

61. Connect the Control wires from the Power/Control wire harness assembly to a switch or switches. To selectone of the 12 different flash functions,

4 OR 6 OUTLETS ON-OFF HIGH POWERBLU (+)SPDT, CENTEROFF SWITCH7.5A FOR 24V15A FOR 12VTO POWERSOURCE+1GRN (+)RED (+)231 32BLK (-)CUSTOMERSUPPLIED DIODE

8FOR NFPA COMPLIANT INSTALLATION, SELECT QUADOR FIVE FLASH MODESWARNING: To achieve the maximum performance from your strobe tubes, do not mix Helix t

TROUBLESHOOTING GUIDE9TroubleshootingNOTE: DO NOT TAMPER WITH THE POWER SUPPLY. THIS UNIT IS SOLD AS A COMPLETEMODULE, AND IS NOT DESIGNED FOR FIELD R