Code-3 SmartPro Configuration Interface Uživatelský manuál stáhnout pdf

SmartPro

Configuration Interface Instructions

Setting up a Configuration

1. Select the lightbar series you wish to program.

2. In the Pattern Selection tab, setup the L1, L2, and L3 patterns you wish to use.

3. In the Takedown/Alley tab, setup the patterns you wish to use.

4. In the ArrowStik tab, setup the arrowstick configuration.

Saving Configuration to File

1. To save the configuration, go to File -> Save Configuration.

2. Enter in a file name

3. Press Save. (The resulting file will have the extension .c3c.)

Loading a Configuration File

1. Loading a configuration file can be done in two ways.

a. Double click the .c3c file you wish to load and the application will launch with the file loaded.

b. To manually load a file, go to File -> Load Configuration and select the file you wish to load.

Writing Configuration to the Handheld Unit

1. To write a configuration to the handheld unit, plug a USBA to micro usb cable into the computer and the

handheld unit, respectively.

2. In the application, go to File -> Write Device.

3. Follow the supplied instructions. (A popup box should come up; if an Error occurs, try again.)

Reading Configuration from the Handheld Unit

1. To read configuration from the handheld unit, plug a USBA to micro usb cable into the computer and the

handheld unit, respectively.

2. In the application, select the series of lightbar you wish to read configuration from.

3. Go to File -> Read Device.

4. Follow the supplied instructions. (A popup box should come up; if an Error occurs, try again.)

5. After closing the popup box, the configuration values will be populated with the information read from

the handheld unit.

1 2

SmartPro Configuration Interface Instructions Setting up a Configuration 1. Select the lightbar series you wish to program. 2. In the Pattern Se

Programming a Lightbar 1. To program a lightbar, load a configuration into the handheld unit. 2. Next plug the programming cable into the lightbar

Žádné komentáře

Code-3 SmartPro Configuration Interface Uživatelský manuál