Code-3 WingMan for Chevy Impala Uživatelský manuál stáhnout pdf (Strana 3)

Mounting Hardware - All mounting hardware is packed in a small box inside the main carton. There are two brackets

and two mounting plates used to mount the WingMan™ to the vehicle. These are discussed in detail later.

FIGURE 1

Step 2 Align the two halves of the template and tape the template together at the tape lines (see figure 2 and 3)

Note: It is helpful to tape one side of the template down to a flat surface to hold it in place while you

tape the other side to it.

FIGURE 2

FIGURE 3

Installation Instructions-

Step 1 Locate and remove the two template halves from the center page area of this manual. Cut out the two

halves of the paper template. (see figure 1)

1 2 3 4 5 6 7 8 ... 15 16

Žádné komentáře

Code-3 WingMan for Chevy Impala Uživatelský manuál Strana 3