Code 3 SuperVisor Průvodce řešením problémů

Read all instructions and warnings before installing and using.This manual must be delivered to the end user of this equipment.IMPORTANT:Introduction.

10FIGURE 13MR8 Takedown Light AssemblyRefer to Figure 13 for lamp replacement. Remove the lamp assembly from the product by disconnecting the two elec

11PROBLEMLED module notoperating whenpowered.POSSIBLE CAUSEa. Bad power/groundconnection.b. Defective module.SOLUTIONa. Fix connection.b. Replace mo

12Parts ListReference Number Part Description Part Number 1 +12V Cooling Fan T05612 2 *LEDX LED Module *Contact Code 3, Inc for

13Notes

14Notes

15Notes

16Revision 2, 07/07 - Instruction Book Part No. T09626©2004 Public Safety Equipment, Inc. Printed in USAWARRANTYCode 3, Inc.'s emergency devices

2The use of this or any warning device does not ensure that all drivers can or will observe or react to anemergency warning signal. Never take the ri

3Unpacking & Pre-installationCarefully remove the SuperVisor™ and place it on a flat surface, taking care not to scratch the lenses or damage the

4FIGURE 3FIGURE 2Attach brackets to sun visor retaining clips In order to remove the sun visor retaining clip, unscrew the one torx screw holding it

5FIGURE 4FIGURE 5Attaching the pivot arm bracketsAttach the outer brackets that are supplied noting the difference between passenger and driver side b

6FIGURE 6Mounting the SuperVisor™Before mounting the SuperVisor, apply gasket stripping to the front edge of the lower chassis in order to prevent scr

7Mounting the SuperVisor™ (continued)The two center brackets should line up with the holes in the SuperVisor's lower chassis. Using the supplied

8Wiring Diagram

9Wiring InstructionsLarger wires and tight connections will provide longer service life for components. For high current wires it ishighly recommende