Code-3 235H Remote Strobe Power Supply Uživatelský manuál

INSTALLATION& OPERATIONMANUAL235HTMREMOTE STROBEPOWER SUPPLYIMPORTANT:REMOTE STROBEPOWER SUPPLYContents:Introduction ...

10

11

Public Safety Equipment, Inc.10986 N. Warson RoadSt. Louis, Missouri 63114-2029—USAwww.code3pse.comWARRANTYThis product was tested and found to be ope

IntroductionThe 235H Series Remote Strobe Power Supply represents the latest in state-of-the-art strobe warningtechnology. The latest in MOSFET techno

The use of this or any warning device does not insure that all drivers can or will observe orreact to an emergency warning signal. Never take the rig

Installation and MountingMOUNTING THE MODEL 235H REMOTE STROBE POWER SUPPLYTo obtain maximum performance and durability the Model 235H should be mount

2. After the cables have been properly routed for each strobe head they will have to be terminated with thethree pin AMP socket housings provided. Th

3. With the AMP 3 pin connectors terminated properly , plug each cable into the appropriate 3 position socketon the 235H strobe power supply, see Fig

Switching Control Variations and ConnectionsThe following diagrams show some of the wiring configurations possible for the various flash modes availab

MaintenanceThe 235H Remote Strobe Power Supply has been designed to provide trouble free service. In case ofdifficulty, refer to the troubleshooting

INTERNAL FUSE REPLACEMENTIn the event that is determined the internal fuse needs to be replaced, the following procedure should be used(See Figure 5):