Code 3 SuperVisor Servisní příručka stáhnout pdf (Strana 1)

INSTALLATION

& OPERATION

MANUAL

Read all instructions and warnings before installing and using.

This manual must be delivered to the end user of this equipment.

IMPORTANT:

Introduction ...........................................................................2

Unpacking & Pre-Installation ................................................2

Installation & Mounting ......................................................3-7

Wiring Instructions & Wiring Diagram .................................8

Fusing LED Flash Pattern Selection & Troubleshooting .......9

Exploded View, Parts & Hardware List ..........................10-11

Aiming the Take Down/Warning Lights .......................... 11-12

Upper Gasket During Installation ........................................13

Notes .............................................................................14-15

Warranty .............................................................................16

CONTENTS:

For future reference, record your product's serial no. here __________________________________________

INSTALLER:

SuperVisor U™

With Torus™ Technology

Interior Lighting System

Patents Pending

PASSENGER SIDE ONLY VERSION

FULL LENGTH VERSION

1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1 - With Torus™ Technology

INSTALLATION & OPERATION MANUALRead all instructions and warnings before installing and using. This manual must be delivered to the end user

Strany 2 - Introduction

10Parts ListReference Number Part Description Part Number Quantity

Strany 3

11Hardware/Parts-Cont. Items 17 Thru 21 Not Shown in Exploded ViewReference Number Part Description

Strany 4

12FIGURE 8FIGURE 9FIGURE 10Adjusting/Aiming the Take Down/Warning Lights-Cont.

Strany 5 - FIGURE 1

13 For Problems with the Upper Gasket during installation!If you experience problems with the Upper Gasket during installation, follow the

Strany 6 - FIGURE 3

14NOTES:

Strany 7 - INNER MOUNTING BRACKET

15NOTES:

Strany 8 - WIRING DIAGRAM

Strany 9 - Changing Flash Patterns

2IntroductionThe SuperVisor U™ (hereafter calld "unit") is an interior lighting system that ts in the visor area near the top of the windsh

Strany 10 - Parts List

3 Installation & Mounting Instructions-Full SuperVisor U or Passenger Side Only SuperVisor UNote to the installer: The following steps for the

Strany 11

4Installation and Mounting Instructions: Cont. Step 4 Have an assistant hold either the Passenger or the Driver side of the the Unit up to the vehicle

Strany 12 - FIGURE 10

5FIGURE 2 STANDARD ROUND OUTER MOUNTING BRACKETOVAL OUTER MOUNTING BRACKETRECTANGULAR OUTER MOUNTING BRACKETSUV (TAHOE) OUTER MOUNTING BRACKETSTANDARD

Strany 13 - FIGURE 11

OUTER MOUNTING BRACKET ASSEMBLYSINNER MOUNTING BRACKET ASSEMBLYSMOUNTING HOLE LOCATION CHOICESMOUNTING HOLE LOCATION CHOICESUNDER SIDE VIEW OF UNIVERS

Strany 14

RECOMMEND 1/8" RADIUS 2XRECOMMEND 1/8" RADIUS 2XCUT OFF AS SHOWN FOR DRILLED AND FASTENED BRACKETSUSE HOLES AS A TEMPLATE TO DRILL MOUNTING

Strany 15

PASSENGER SIDEDRIVERSIDELT BLUEPURPLEWHITE RED THIS WIRE IS ALSO FOR TAKE DOWNS WHEN SO EQUIPPEDORANGEGREEN/W

Strany 16 - PRODUCT RETURNS

LED Fusing ConsiderationsAlthough the average current draw per module is very low, due to the type of circuit used to power each module, the instanta